Land Rover Transmission & Drivetrain parts

Jaguar, Land Rover, genuine Bolt-flanged head 3 pcs No: 255467

Land Rover Part Number: 255467 - Flanged-Head Bolt - Swivel Pin Housing 255467 is a flanged-head bolt for the swivel pin housing. Fitted to the swivel pin housing, this bolt provides the securing fastener that holds the swivel pin housing in place.

Jaguar, Land Rover, genuine bolt 1pcs No: UYG500050

M10 double hex-head bolt used on the swivel housing. It secures the oil seal retainer to the swivel housing and should be inspected for corrosion, thread damage or distortion whenever the swivel housing or drive shafts are serviced.

Genuine Jaguar, Land Rover, bolt 2 Pcs No: BH110121L

Hex-Headed Bolt M10 x 60mm - Defender, Discovery 1, Range Rover Classic

Genuine Jaguar, Land Rover, screw 2 Pcs No: RYP501050

Pan-headed Torx screw with an M6 x 25mm specification. Fitted where small components require a secure fixing, this pan-headed Torx fastener secures various trim and minor components on applicable Land Rover models.

Jaguar, Land Rover, genuine bolt 1pcs No: FC112147

Flange-head bolt. Fitted to the front knuckle and hub assembly, this bolt fastens components and the integral flange head helps to distribute the clamping load, reducing localised stress on the joint

Genuine Jaguar, Land Rover, screw 3 Pcs Nr: FS106167L

M6 x 16mm flanged head set screw. It is supplied for general-purpose use across multiple Land Rover models where a metric flange-head screw is specified to secure assemblies.

Genuine Jaguar, Land Rover, ring 1 Pcs No: TDL500080

An output shaft snap ring for the MT82 manual transmission. It secures and retains the output shaft components inside the MT82 gearbox to prevent axial movement.

Genuine Jaguar, Land Rover, washer 1 Pcs No: TUF100090

Selector Mechanism External (1.8 K16 Petrol,2.0L I4 8V TCIE,Manual Transmission)

Genuine Jaguar, Land Rover, bolt 1 Pcs No: LR039049

Hex-headed bolt used to fasten components on front axle cases, transmission mountings and rear cross members across multiple Land Rover models. It provides the clamping required to secure these structural and drivetrain assemblies; when fitting, ensure mating faces and threads are clean and the correct fastener specification and torque from the vehicle repair manual are used. Inspect the bolt for corrosion, thread damage or distortion and replace if any defects are found.

Genuine Jaguar, Land Rover, washer 1 Pcs Nr: TYF101040

Jaguar, Land Rover, genuine propshaft bolt 7 pcs No: LR045409

A 3/8 inch UNF propeller shaft bolt. Fitted to both front and rear propeller shafts, this bolt secures the shaft flanges together to retain the propshaft. Commonly referred to as a propshaft bolt, it uses a 3/8" UNF thread and is fitted to a range of Land Rover models

Genuine Jaguar, Land Rover, bolt 1 Pcs Nr: T4A10922

Front Differential Drive Unit (All Wheel Drive)