94 Suspension & Steering parts for Land Rover from our Hungary workshop — OEM and checked used components. Ships within the EU with no customs.
QRH100030 is a shear lock bolt for the steering column. It secures the steering lock to the steering column, and the bolt head is designed to shear off when correctly tightened so the head cannot be easily removed.
€7.35
New7 in stockincl. VAT
LR053817 is an M10 x 25mm Torx screw used to secure components within steering wheel assemblies. Fitted as a Torx-head M10 fastener, it provides the threaded connection that holds steering wheel parts together during assembly and service.
€2.12
New3 in stockincl. VAT
LR097372 is a bolt used to secure structural components within the front crossmember and stabiliser bar assemblies. It is fitted in front suspension locations to retain and align crossmember and anti-roll bar components.
€9.10
New4 in stockincl. VAT
FTC3648 is a stub axle gasket. Fitted between the stub axle and the swivel pin housing or hub assembly, this gasket seals the joint on applicable Land Rover front and rear hubs.
€4.55
New9 in stockincl. VAT
Rear anti roll bar drop link
€45.78
NewLast oneincl. VAT
FY116056 is an M16 flanged nylon-insert lock nut. Fitted to the rear suspension, this flanged nylon-insert lock nut secures knuckles and suspension arms. Commonly referred to as a flanged nyloc nut or nylon-insert lock nut, it is supplied for use where a retained locking feature is required on M16 fastenings in the rear suspension assembly.
€1.59
New4 in stockincl. VAT
QYG500140 is an M12 X 95 shanked hex-headed bolt used to secure the steering box to its mounting. It is specified for Land Rover Defender models built 2007 to 2016 and is used on the Steering Box Power Adwest Lightweight variant (with power steering, fixed ratio) from VIN 7A000001 onwards.
€4.77
New6 in stockincl. VAT
LR083989 is an air compressor connector which links the valve block to the delivery pipe within the vehicle's air compressor system. Fitted between the valve block and delivery pipe, it provides a sealed connection to maintain the delivery of compressed air to downstream components.
€27.70
New2 in stockincl. VAT
ANR3482 | Bolt - M12 - Flange Head - Front & Rear Suspension.
€13.50
New3 in stockincl. VAT
QYG500100 is an M8 x 33 Torx bolt used to secure the steering column universal joints. It fastens the universal joint coupling within the steering column assembly and is supplied as a Torx-head fastener for correct tool engagement.
€2.99
New9 in stockincl. VAT
LR026275 is a flanged nut used to fasten components within the steering gear assembly. Fitted to the steering gear, this flanged nut secures mating parts and helps maintain the correct assembly of the steering mechanism
€2.98
New6 in stockincl. VAT
FN112056 is an M12 flanged hex nut. Fitted to engine mountings and front suspension strut assemblies, it secures the mounting studs and uses its integral flange to help distribute load and reduce point loading. Also referred to as an M12 flange nut, this item should be inspected for thread damage, distortion or corrosion and replaced if compromised; always fit to the correct stud and tighten to the manufacturer's specified torque.
€1.55
New9 in stockincl. VAT
K3dparts Pro Locator
