69 Brakes parts for Land Rover from our Hungary workshop — OEM and checked used components. Ships within the EU with no customs.
FTC124 is a swivel pin thrust washer. Fitted to the front axle swivel pin housing, this thrust washer is specific to vehicles equipped with a four-wheel anti-lock braking system.
€14.99
New8 in stockincl. VAT
SYG000013 is an M12 x 35mm male Torx bolt used to secure the rear brake caliper carrier bracket. Fitted to the rear brake carrier, this bolt holds the caliper carrier in position within the rear brake assembly.
€2.10
New11 in stockincl. VAT
SSB101331 is an Antilock Brake Sensor and Bracket Assembly. Fitted to Freelander vehicles, the sensor operates within the anti-lock brake system to monitor wheel speed and provide the wheel speed signal required by the ABS control module.
€146.00
NewLast oneincl. VAT
Brake hose.
€126.00
NewLast oneincl. VAT
LR058021 is a front right-hand brake hose. Fitted to right-hand drive Range Rover Sport models, it carries hydraulic pressure from the vehicle brake pipe to the right-hand front caliper, providing the connection required between the brake pipe and the caliper.
€88.34
New3 in stockincl. VAT
Brake hose
€128.10
NewLast oneincl. VAT
LR000093 is an M14 x 40mm hex-headed bolt used to secure the front brake caliper carrier. This hex-headed bolt fastens the front brake caliper carrier to the vehicle and should be fitted and torqued to the manufacturer's specification during assembly.
€4.48
New26 in stockincl. VAT
LR007055 is a front vented brake disc, 380MM. Fitted to the front axle, this disc provides the rotating braking surface and works with the brake pads and caliper to convert vehicle motion into thermal energy. The vented construction increases airflow through the disc faces to reduce heat build-up during repeated or sustained braking. It mounts to the wheel hub and is specified for vehicles using 16-inch front disc assemblies; replacement should match the original part number and mounting pattern to preserve rotor runout and pad contact characteristics.
€199.76
NewLast oneincl. VAT
SMV500010 is a guide pin bolt for the brake caliper. It secures the caliper guide pin within the caliper assembly, retaining the sliding pin so the caliper can move freely and the brake pads can wear evenly. Fitment applies to the front and/or rear calipers on the Land Rover models listed below; inspect the bolt when servicing calipers or replacing pads.
€2.99
New2 in stockincl. VAT
K3dparts Pro Locator
