12 Suspension & Steering / Wheel bearings / hubs parts for Jaguar from our Hungary workshop — OEM and checked used components. Ships within the EU with no customs.
FRC2884 is a 0.005 inch swivel pin shim. It fits between the swivel pin and the swivel housing to precisely set the swivel pin clearance and remove unwanted play, helping to prevent premature wear of the swivel assembly.
€9.54
incl. VAT
€7.42
FRC2883 is a 0.003 inch swivel pin housing shim. Fitted to the front axle swivel pin housing on applicable models, this shim is the correct thickness specified for use in the swivel pin housing assembly.
€10.60
The 3/8 UNF x 1-1/4 bolt fitted to front flange assemblies on applicable Land Rover models. It secures the flange components and maintains correct alignment of the assembly; the bolt and mating threads should be inspected for damage or contamination during installation and servicing.
RUE000010 is a 51mm circlip. It locates and retains the wheel bearing within the hub knuckle, preventing axial movement on specified front and rear axle applications - confirm the correct axle and VIN before ordering.
€12.72
FRC8700 is a wheel hub locknut (early type) used on beam axle hubs. On early hubs two of these locknuts are fitted either side of a tab-type lock washer to clamp the hub nut and retain the hub assembly. Please note: on later hub designs (from approx 1998) the locking tab is integrated into the nut and RFD100000 is used instead.
€8.72
LR024507 is a flanged hex-headed bolt M12 x 80mm. It secures knuckle and hub components on the front and rear assemblies, fastening the knuckle and hub hardware.
€8.60
TOF100030 is a 15.2mm hub spacer with a blue colour code. Used on front and rear wheel bearings to set the bearing spacing within the hub assembly.
€18.10
TOF100050 is a 15.0mm wheel bearing spacer used to locate wheel bearings in the hub assembly. Fitted to front and rear hub assemblies, the spacer ensures correct bearing position within the hub and carries the black colour code.
€15.95
Axle Nut Front or Rear Wheel Hubs.
€12.10
FC112146 is an M12 flange head bolt, 12 x 70mm. Fitted to the front knuckle and hub assembly on Discovery 3 (L319) models, this flange bolt secures the knuckle and hub components together. Inspect the fastener for thread damage or corrosion during service and replace if any defect is found; install to the manufacturer's recommended fastening specification.
€5.19
K3dparts Pro Locator
